Build and Audition Your First Modular Synth Patch

Start with a short audio path

Add an oscillator, a gain module, and an output. Connect the oscillator through the gain module to the output. Start audio and audition a note at a comfortable level.

Add one filter

Insert a filter in the audio path and listen while changing cutoff. Follow the connections in the graph to check that the filter is between the source and output.

Add one modulation route

Connect an envelope to a supported gain or filter parameter. Make an audible change to its attack or decay. Follow the modulation connection if changing the envelope makes no difference.

Keep comparisons easy to hear

Change one connection or control at a time. Audition the same notes while you compare. Add effects after you can hear how the source, filter, and envelope behave together.

Find the graph, the inspector and the output monitor

Open the Tone Forge desktop editor and identify the graph in the center and the controls for the selected module at the right. The starting sound already shows a route from oscillators through a mixer and filter into the output. Select an oscillator and look at its waveform and level before touching any controls. Follow its audio connection all the way to the output. If you prefer to experiment with the starting patch, use that route as the reference for the exercises below.

Use Start audio to activate the audio engine, then hold the audition control for C4. Start with a comfortable listening level and watch the output monitor while you do it. If the meter shows activity, listen for a clear tone and release the preview control. That pair of actions gives you a repeatable note to compare throughout the session. When the meter stays still, check the audio status and the route to the output before changing the synth design.

Make a change you can recognize on the same note

Select the oscillator. Change its waveform or level, then audition C4 at the same listening volume. Describe the difference you hear. Adjusting the shape changes the source material that reaches the mixer and filter. Adjusting level changes how strongly that source contributes. If the patch uses a second oscillator, make the change on the selected oscillator only so the comparison has a clear cause.

Next, select the filter and move its cutoff manually. Listen through a few cutoff positions on the same note. Return it to a value where the patch is audible and where a modest amount of movement changes the tone. That is a convenient place to try envelope modulation. On the graph, confirm the edge into the filter and the edge leading downstream so that the filter you are changing belongs to the path you are hearing.

Compare a short attack and a slow attack

Connect an envelope to a parameter that accepts modulation, such as the selected filter cutoff or a gain control in the patch. Try a clearly short attack first and keep the remaining controls steady. Then increase the attack time enough to make the change obvious. Audition the same note again and listen for the shape of its beginning. Try release separately after the attack feels right. Work at a comfortable level so that the timing of the motion is easier to focus on.

If the two attacks sound similar, check that the envelope reaches the intended parameter and that its amount has room to move the control. Move the destination by hand once more to verify that it produces an audible difference. Then restore the base value and compare the envelope settings again. This isolates whether the issue is in the control route or the sound passing through the audio route.

Check the output after adding a module or an effect

When you change the graph, listen to the same note before and after the edit and glance at the output monitor. An unexpectedly quiet patch is easier to diagnose when you can name the last operation. Follow the active source to the final output and check each changed connection and level along that route. Try adding one output effect only after the unprocessed patch is working. A short phrase lets you hear the effect on both the beginning of each note and the sound after you release it.

The signal flow guide explains how these audio and modulation routes interact in a larger patch.

You can also read this walkthrough and the signal flow guide in Simplified Chinese.